AS NZS 5263.1.7 pdf download – Gas appliances Part 1.7: Domestic outdoor gas cooking appliances
AS NZS 5263.1.7 pdf download – Gas appliances Part 1.7: Domestic outdoor gas cooking appliances
2.1 Scope
This Clause of AS/NZS 5263.0 applies.
2.2 General design requirements
This Clause of AS/NZS 5263.0 applies, except as modified below.
2.2.3 Fitting of flame safeguards
Burners shall be protected by a flame safeguard if —
(a) the burner is used to heat a smoker oven or an outdoor oven; or
(b) the appliance is intended to be installed in or connected to the consumer piping of a boat or a caravan.
2.2.12 Provision for removal of condensate
Not applicable.
2.2.101 LP Gas cylinder mounting means
Mobile LP Gas outdoor cooking appliances shall be provided with a means to support the cylinder and This requirement is deemed to be met if the appliance includes —
(a) an integral mounting means for a cylinder; or
(b) a cylinder compartment.
2.2.102 Means to prevent accidental closure of hood or lid
A hood or lid permanently attached to an appliance shall be provided with suitable means to prevent accidental closure.
2.2.103 Provision and location of grease receptacle
A barbecue shall be provided with a non-disposable grease receptacle for the collection of any excess cooking grease.
With the appliance in its installed position, any grease receptacle shall be positively located and capable of being removed without tools and without causing spillage.
2.2.104 Weatherproofing
Appliances designed for fixed outdoor installation shall be provided with, or incorporate, weatherproofing to protect the appliance while not in use.
2.2.105 Pan supports for side burners
The pan support(s) for side burners shall be secure to prevent displacement during normal use.
2.2.106 Prevention of separation of barbecues from detachable trolleys
For an appliance supported by a detachable trolley, means shall be provided to prevent inadvertentseparation of the appliance from the trolley.
2.2.107Adequacy of means of support
Appliances having more than two wheels shall be provided with means to prevent movement of theappliance when in use.
2.2.108 Smoker oven or outdoor oven —Prevention of inadvertent placement ofutensils in a flame
Smoker ovens or outdoor ovens shall be designed so as to prevent the accidental placement of shelves,cooking utensils or wood chip containers in a position where they may be impinged upon by aburner flame.
2.2.109 Smoker oven or outdoor oven — Prevention of accidental removal of shelvesSmoker oven or outdoor oven shelves shall not be capable of being accidentally removed.2.2.110 smoker oven or outdoor oven — Stability of shelves
Smoker oven or outdoor oven shelves shall be stable and horizontal when in position in the appliance.2.2.111 Smoker oven or outdoor oven — Door stability
Smoker oven or outdoor oven doors shall be so constructed that, when fully open, they will remain inthat position.
2.2.112Smoker oven or outdoor oven — Provision of explosion relief for applianceswith door locks
Positive door locks shall not be used unless adequate provision for explosion relief is made.2.2.113 Smoker oven — Flame contact with smoker materials
The burner flames shall not come into direct contact with the smoker materials used (e.g. wood chips).2.3Materials
This Clause of AS/NZS 5263.0 applies.
2.4Design for assembly and installation
This Clause of AS/NZS 5263.0 applies, except as modified below.2.4.3 Gas inlet connection
Where the appliance is to be connected to consumer piping,the gas inlet connection shall —(a)
have a thread in accordance with AS ISo 7.1 or AS 1722.2;
NOTE See AS 3688 for guidance on the appropriate class of thread for various types of connection.
(b)
have a quick connect device in accordance with AS 4627, Type 1 or Type 2; or
