ISO 15524 pdf download

ISO 15524 pdf download Pneumatic fuid power — Cylinders — Single-rod short-stroke cylinders, 1 000 kPa (10 bar) series, bores from 20 mm to 100 mm
This International Standard establishes a metric series of single-rod pneumatic short-stroke cylinders withbores from 20 mm to 100 mm (inclusive) for use at maximum working pressure of 1 000 kPa [10 bar 1with andwithout magnetic function. They are not equipped with adjustable cushioning, so their application is restrictedto those systems where adjustable cushioning is not required.
2Normative references
The following referenced documents are indispensable for the application of this document.For datedreferences, only the edition cited applies.For undated references, the latest edition of the referenced document(including any amendments) applies.
ISO 3320,Fluid power systems and components —Cylinder bores and piston rod diameters — Metric seriesISO 4393,Fluid power systems and components —Cylinders — Basic series of piston strokes
ISO 5598,Fluid power systems and components – Vocabulary
ISo 6099,Fluid power systems and components —Cylinders — ldentification code for mounting dimensionsand mounting types
ISO 16030,Pneumatic fluid power — Connections — Ports and stud ends
3Terms and definitions
For the purposes of this document, the terms and definitions given in lSO 5598 apply.
4Bore sizes
Cylinders with the following bore sizes, AL, expressed in millimetres, are included in this series, in accordancewith lSO 3320:
20- 25-32 -40-50 – 63-80- 100
5 Nominal stroke
5.1The nominal strokes shall be selected from the recommended values given in ISO 4393, as shown inFigure 1.The maximum stroke length should not exceed 100 mm.
5.2 The nominal stroke tolerances are given in Table 1.
6 Dimensions
The basic dimensions of cylinders shall conform to the requirements given in Figures 2, 3 and 4 and Tables 2 and 3.
7 Mounting types
This International Standard includes the following mounting types, identifed in accordance with ISO 6099.
— MB 1: Body, through bolt hole (see Figure 2 and Table 2);
— MX 8: Head and cap, tapped (see Figure 3 and Table 2);
— MX 9: Body, through two bolt hole and both ends two tapped (see Figure 4 and Table 3).
NOTE Letter code MX 9 should be added to ISO 6099.
8 Example of ordering designation
A pneumatic short-stroke cylinder, mounting type = MB 1, bore = 40 mm, stroke = 30 mm, shall be designated as follows:
Short-stroke cylinder ISO 15524 – MB 1 – 40×30
9 Identifcation statement (reference to this International Standard)
Use the following statement in test reports, catalogues and sales literature when electing to comply with this International Standard:
“Dimensions of pneumatic short-stroke cylinder are in accordance with ISO 15524:2011, Pneumatic fuid power — Cylinders — Single-rod short-stroke cylinders, 1 000 kPa (10 bar) series, bores from 20 mm to 100 mm.”