IEC 60399 pdf – Barrel thread for lampholders with shade holder ring

IEC 60399 pdf – Barrel thread for lampholders with shade holder ring

IEC 60399 pdf – Barrel thread for lampholders with shade holder ring
This international standard applies to lampholders designed with a barrel thread for shadeholder rings designed to keep attachments to lampholders in place.
lt also covers barrel threads for shade holder rings.
Attention is drawn to lampholder safety standards lEC 60238,IEC 60400,IEC 60838-1 andIEC 61184 which cover all aspects of lampholder safety and to the luminaire standardlEC 60598-1 which contains information for luminaire design.
1.2 Normative references
The following referenced documents are indispensable for the application of this document.For dated references,only the edition cited applies.For undated references, the latest editionof the referenced document (including any amendments) applies.
IEC 60238,Edison screw lampholders
IEC 60400,Lampholders for tubular flurorescent lamps and starterholdersIEC 60598-1,Luminaires – Part 1: General requirements and tests
IEC 60838-1,Miscellaneous lampholders – Part 1: General requirements and tests
lEC 61184,Bayonet lampholders
2Terms and definitions
For the purposes of this document, the following terms and definitions apply.
barrel thread
external thread on the outer shell of a lampholder intended to support a shade ring
shade ring
cylindrical component having an internal thread to engage a corresponding support on theouter shell of a lampholder and intended to carry or retain a shade.
3 Requirements to barrel threads
3.1General requirements
For B15 and B22 lampholders, barrel threads other than those shown in this standard may beused, providing they comply with Figure 8 of lEC61184.

The previous

IEC 60384-2 pdf - Fixed capacitors for use in electronic equipment – Part 2: Sectional specification – Fixed metallized polyethylene-terephthalate film dielectric DC capacitors:

The next

IEC 60445 pdf - Basic and safety principles for man-machine interface, marking and identification – Identification of equipment terminals, conductor terminations and conductors

Related Standards